Successfully replace pump, prestorat, electronic controller.Ĭheck for the presence of a contact in the connectors and harness between the controller and the control panel.Ĭheck the serviceability of the button on the control panel. If it does not, check the pump itself (220 V supplied), its connector, and an electronic controller.Ĭheck the water level sensor, as well as its connection to the electronic (pcb)controller.Ĭheck the filter and drain hose for clogs. If the actions listed do not reveal a faulty element, level sensor, and electronic controllerį05 drain pump does not work or does not generate “EMPTY TANK” signal after level sensor discharge modeĬheck the reliability of the connection between the electronic controller and drain pump.Īt the time of perceived activation of the drain pump, check for the presence of mains voltage at its contacts. in this matter:Ĭheck the connection between the electronic (pcb) controller and the level sensor, as well as the sensor. As a result, it turns out that at the same time the bay is turned on (water inlet valves are open) and water drain (drain pump is on).
In this case, water is poured into the CM tank at the level of the “tank”. Replace electronic (pcb) module of the washing machineį02 The signal from the taco sensor about the rotation of the drive motor is not fed to the electronic pcb controllerĬheck the contacts of the CNE connector on the electronic module of the washing machineĬheck the connection between the motor and the electronic module.į03 temperature sensor is faulty, or the heater water heater relay is “hot”Ĭheck the contacts wire of the CAN connector on the electronic(pcb) module.Ĭheck the integrity of the wires from the sensor to the connector.į04 Water level sensor (pressure switch) is faulty The water level sensor simultaneously generates the “FAN” and “EMPTY TANK” signals (although only “EMPTY TANK” should be generated).
The decoding of codes is the same for washing machines Indesit and other series of Ariston Ariston washing machines Error codes.Įrror Code Error Code Interpretation Washing Machine Potential Malfunctionį01 short circuit in control circuit of CM drive motorĬheck the connection of the washing machine’s electronic moduleĬheck for the presence of contacts and water.Ĭheck the motor wire connection for mechanical damage to the wire breakage. Thus, if the indicator flashes eight times, then stops, then 8 times and then means that this error code is F08, similarly to other errors. Starting from F01 to F12 for the washing machine Indesit – a new series of “development”.į01 to F15 – For drying washing machines.If your washing machine has only one indicator light (EVO-I control system), the error code is determined by the number of flashes in a cycle after a pause.
All error codes starting from F01 to F11 are valid for Indesit and Ariston 2000 washing machines.